-------------------------------------------------------------------------------
  Famtasia Taperecorder Specification (01/24/2000) by nori.
-------------------------------------------------------------------------------

[FILE SPEC]
Basically it's OK that you simply convert your cassette tapes into WAV format, but the following restriction applies:

 1) File format is fixed in "44100Hz 16bit mono".
     (Other format is available in the future)
 2) Make file in good sampling environment.
    Set especially the zero-line.
    Because it's not too clever algorithm (^^; you get n.g. in the following case.

  (OK)
      ***     *
     *   *   * *     *
     *   *   * *     *
   --------------------- <-0
   *      * *   *   *
   *      * *   *   *
  *        *     ***
        0      1     0   <- probe signal

  (NG)                ***
      ***     *      *   *
     *   *   * *    *
     *   *   *  *   *
   --------------------- <-0
   *      **     **
   *               
  *              
        0     1?0?  1?0? <- probe signal

[HOW TO RECORD WAV]
 1) Select "keyboard" in "Ext. Connector" in key setting menu.
 2) Set the target software ready for recording.
 3) You can get pop-up menu after right-click on the screen.
    Select [New Save].
 4) Choose the name of the WAV file to save in.
 5) Manipulate the target software to start recording.
 6) After recording is finished, right-click again on the screen to output pop-up menu and select [Stop Tape].
  ! Stop recording immediately after finishing recording, or it makes a long WAV file to end up disk-full of your HDD.

[HOW TO PLAY WAV]
 1) Select "keyboard" in "Ext. Connector" in key setting menu.
 2) Set the target software ready for recording.
 3) You can get pop-up menu after right-click on the screen.
    Select [New Play].
 4) Choose the name of the WAV file to play.


